Half-day watchmaking course including a watch to take home

In this watchmaking course, you get the chance to assemble your own watch. You can choose from a variety of watch parts (movement, dial, hands, case, strap). You’ll be supported by a master watchmaker. You then take the finished piece home with you.

You can choose between:

• Hand-wound watch
• Automatic watch

You have to wind a mechanical watch with manual winding once a day. This is done by turning the crown clockwise.

• ETA 6497 manual movement, made in Switzerland
• 42 hours power reserve
• Functions: hours, minutes, and small seconds (at 9:00)
• Diameter of the steel cases from 42 mm to 48 mm
• Strap width 22 mm
• Top sapphire glass and transparent mineral glass bottom
• Water resistance of 3 ATM (30 meters)
• Watch warranty: 2 years

The automatic mechanical watch winds itself up when you wear it. You generate energy through the movement of your wrist. The Initium automatic watch has a power reserve of 38 hours and stops after that time if it is not worn. Afterward, it can be manually wound via the crown.

• ETA 2892 or SW300 automatic movement, made in Switzerland
• 38 hours power reserve
• Functions: hour, minute, and second, as well as a date function for non-skeletonized movements
• Diameter of the steel cases from 33 mm to 42 mm
• Strap width 22 mm
• Upper sapphire crystal and transparent mineral glass case back
• Water resistance of 3 ATM (30 meters)
• Watch guarantee: 2 years

• no prior knowledge required